Table of Contents
Advertisement
Disclaimer
■
To take full advantage of the unit, you should be familiar with the engine.
■
All information, illustrations, and specifications contained in this manual are based
on the latest information available at the time of publication. The right is reserved
to make change at any time without notice.
■
Neither LAUNCH nor its affiliates shall be liable to the purchaser of this unit or
third parties for damages, losses, costs or expenses incurred by purchaser or
third parties as a result of: accident, misuse, or abuse of this unit, or unauthorized
modifications, repairs, or alterations to this unit, or failure to strictly comply with
LAUNCH operating and maintenance instructions.
■
LAUNCH shall not be liable for any damages or problems arising from the use of
any options or any consumable products other than those designated as Original
LAUNCH Products or LAUNCH Approved Products by LAUNCH.
Safety Precautions and Warnings
To prevent personal injury or damage to vehicles and/or this tool, please read this
user's manual first carefully and observe the following safety precautions at a minimum
whenever working on a vehicle:
■
Always perform automotive testing in a safe environment.
■
Do not attempt to operate or observe the tool while driving a vehicle. Operating or
observing the tool will cause driver distraction and could cause a fatal accident.
■
Wear safety eye protection that meets ANSI standards.
■
Keep clothing, hair, hands, tools, test equipment, etc. away from all moving orhot
engine parts.
■
Operate the vehicle in a well-ventilated work area: Exhaust gases are poisonous.
■
Put blocks in front of the drive wheels and never leave the vehicle unattended
while running tests.
■
Use extreme caution when working around the ignition coil, distributor cap, ignition
wires and spark plugs. These components create hazardous voltages when the
engine is running.
■
Put the transmission in P (for A/T) or N (for M/T) and make sure the parking brake
is engaged.
■
Keep a fire extinguisher suitable for gasoline/chemical/ electrical fires nearby.
■
Don't connect or disconnect any test equipment while the ignition is on or the
engine is running.
■
Keep this tool dry, clean, free from oil/water or grease. Use a mild detergent on a
clean cloth to clean the outside of the tool, when necessary.
■
Please use the DC 5V power adaptor to charge this tool. No responsibility can be
assumed for any damage or loss caused as a result of using power adaptors other
than the right one.
Creader Professional 129 EVO / EVO+
EN
3
Advertisement
Table of Contents
