Table of Contents
Advertisement
MAINTENANCE
4) Remove the door catch plate.
6) Remove glass retainers on sides first (3 each side) then
remove two center retainers.
Note: Center glass retainers are glued to center glass.
6)
Remove giass from extrusions. When removing center
glass, leave white insulation in place.
Installing Glass
1)
Install both center and side glass onto extrusions as per
diagram.
2)
Place giass assembly into door frame.
3)
install retainers by placing 1 dropofgluewherepreviously
glued and put in place.
4)
Install side retainers.
5)
Install door catch plate.
6)
Install the 24 nuts loosely, do not tighten yet.
7)
Tighten side panels nuts us¬
ing the follovwng procedure;
a.
tighten top & bottom out¬
side corner nuts (2)
b.
tighten inside nuts (3)
c.
tighten top & bottom in¬
side corners (2)
8)
Tighten the 10 nuts on center giass retainer.
9)
Repeat step 7 for other side panel.
10) Replace new gasket by gluing It in place.
11) Install door onto stove and check the seal.
PANEL DOOR
1)
Remove the door from the unit and place on a soft surface
to prevent scratching.
2)
Pull out the door gasket.
3)
Remove the nuts holding the glass retainers in place.
4)
Remove the glass retainers (sides, top and bottom) and
the door catch plate.
5)
Replace the giass. The glass must have gasketing
around it
6)
Reverse the previous steps, replace the retainers and
fasten with the nuts but do not overtighten, as this can
breakthe glass. Note; the door catch plate fits on top of the
left side refiner.
7)
Put gasket glue on the retainers, but do not put glue on the
screws. Replace the door gasket, the two ends butt tight
together on the bottom edge of the door.
8)
Replace door on the stove and check the seal.
24
U27-1 Regency ULTIMATE Rear Vent Direct Vent Freestanding Gas Heater
Advertisement
Table of Contents
