Table of Contents
Advertisement
INSTALLATION
LOG INSTALLATION
WARNING' Dangerous operating conditions may occur if these logs are not positioned in their approved locations.
Read the instructions below carefully and refer to the diagrams. If logs are broken do not use the unit until they are
replaced. Broken logs can interfere with the pilot and burner operation.
The gas log kit contains the following:
4)
Place the right front log, carefully sliding it down onto the
right pins of the front burner. See diagram 3.
a)
Front Right Log-Part #902-020
b)
Front Left Log - Part # 902-021
c)
Rear log - Part # 902-022
d)
Embers - Part # 902-151 (1 bag)
e)
Lava - Part# 902-154 (1 bag)
(Part # 560-935 for the set of three logs)
1) Removethelogsfromtheboxandcarefuliy unwrapthem.
The logs are fragile, handle with care - DO NOT FORCE
into position.
2) Place the rear log, carefully sliding it down onto the pins,
with the flat side of the log facing the back of the unit. See
'diagram 1.
3) Placetheleftfrontlog, carefully sliding it down ontotheleft
pins of the front burner. See diagram 2.
pins
5)
Distribute the embers along the front burner but do not
cover the burner ports and around the logs. Place the
embers on the floor of the firebox. Place the lava on the
burner tray in front of the left and right front logs. See
diagram 4.
Diagram 4
Large
Embers
14
U27-1 Regency ULTIMATE Rear Vent Direct Vent Freestanding Gas Heater
Advertisement
Table of Contents
