Table of Contents
Advertisement
INSTALLATION
4)
The latches should already be atthe proper setting. If they
are too hard or too easy to close, you may want to adjust
them by loosening the locking nut and turning the latch
catch. See diagram 3.
DOOR INSTALLATION
(Packaged Separately)
1)
Open the two side panels.
2)
Slidethedoor ontothetwo hinge pins makingsurethetwo
pieces are flush together. See diagram 1.
3) Close the door. The latch plate must be centered around
the alignment pin. See diagram 2. If the latch plate
interferes with the corner of the stove you may want to
angle the plate slightly so the door closes easier.
5)
Remove the blue plastic protective coating from the glass.
6)
Test the seal around the door by placing a piece of paper
between the unit and the door, close the door and try to
pull the paper out. If it slips out easily, then the door is not
properly sealed. Tighten or loosen the latch by turning the
latch catch inward or outward. See diagram 3.
Note: The door latch may require adjustment as the door
gasket material compresses after a few fires and
after glass replacement.
Turn the latch catch
inward or outward.
Catch
U27-1 Regency ULTIMATE Rear Vent Direct Vent Freestanding Gas Heater
15
Advertisement
Table of Contents
