Table of Contents
Advertisement
OPERATING INSTRUCTIONS
OPERATING INSTRUCTIONS
1)
Read and understand these instructions before operating
this appliance.
2)
Check to see that al! wiring is correct and enclosed to
prevent possible shock.
3)
Check to ensure there are no gas leaks.
4)
Make sure the glass in the door frame is properly posi¬
tioned. Never operate the appliance with the glass re¬
moved,
5)
Verify that the venting and cap are unobstructed.
6) Verify log placement. If the pilot cannot be seen wrhen
lighting the unit - the logs have been Incorrectly posi¬
tioned.
7) The unit should never be turned off, and on again without
a minimum of a 60 second wait.
SHUTDOWN PROCEDURE
1)
Use the thermostat or remote control to turn off the main
burner.
2)
Turn the main gas control clociwise to the ''OFF" position
to turn off the pilot (push knob in slightly).
3)
Turn off all electric power to appliance if service is to be
performed.
FIRST FIRE
LIGHTING PROCEDURE
IMPORTANT:
Gas cock knob cannot be turned from
"PILOT" to "OFF" unless It is partially depressed.
1)
Turn stove OFF using the Burner "ON/OFF" switch, re¬
mote or thermostat.
2)
Turn gas control knob so indicator points to "OFF' position
and allow 5 minutes for any gas in the combustion cham¬
ber to escape.
3)
Turn gas control knob counterclockwise so indicator points
to the "PILOT" position. Depress the gas control knob
fully. Depress the igniter button several times until the pilot
lights. After approximately one minute, release the gas
control knob. The pilotfiame should continueto burn. If the
pilot does not remain lit, repeat operation allowing a
longer period before releasing gas control knob.
4) V^hen the pilot stays lit, turn the gas knob further counter¬
clockwise to the "ON" position.
5)
Use the thermostat or remote control to turn on the uniL
6)
Rotate the flame height regulator to adjust the flame
height higher or lower.
The first fire in your stove is part of the paint curing process. To
ensure that the paint is properly cured, it is recommended that
you burn your fireplace for at least four (4) hours the first time
you use it with the fan on. When first operated, the unit will
release an odour caused by the curing of the paint, the burning
off of any oils remaining from manufacturing. Smoke detectors
in the house may go off at this time. Open a few windows to
ventilate the room for a couple of hours.
The glass panel may require cleaning after the unit has
cooled down. DO NOT ATTEMPT TO CLEAN THE
GLASS WHILE IT IS HOT.
Note: When the glass is cold and the appliance is lit, it
may cause condensation and fog the glass. This
condensation is normal and will disappear in a few
minutes as the glass heats up.
DO NOT BURN THE APPLIANCE WITHOUT THE
GLASS FRONT IN PLACE.
Advertisement
Table of Contents
