FP PostBase Vision M2 Installation And Safety page 5

Accessories and consumables
• We recommend to use only approved FP equipment and FP original parts.
The manufacturer FP has established the reliability, safety and applicability of
these. The manufacturer cannot assess the reliability, safety and applicability for
products not approved by FP, and therefore cannot vouch for such products.
Full functionality of the PostBase Vision M2 franking machine is only guaranteed at
the time of delivery if original ink cartridges from Francotyp-Postalia are used.
• Only use a power supply unit specified in the section 'Technical Data'.
Make sure that the power supply unit is not damaged.
• Use the supplied power and connection cables or cables that have been approved
by Francotyp-Postalia. Make sure that cables are not damaged.
• When handling ink cartridges, observe the product information enclosed with each
package. Avoid eye and skin contact with the ink. Avoid inhaling ink fumes. Make
sure that ink cartridges do not get into the hands of children. Ingestion of the ink
can be harmful to health. Detailed information can be found on the Material Safety
Data Sheet (MSDS), available at sdb.francotyp.com/en.
• The ink cartridge may be equipped with a clip as transport protection, depending
on the model. Remove the clip before inserting the cartridge. Dispose of the clip.
Never put the clip back on the cartridge in order to prevent damage to the print
nozzle plate, which can cause short circuits, overheating and melting of components.
General safety instructions
• Set up and install the PostBase Vision M2 franking machine as described in the
'Installation and commissioning' section.
• Never transport the PostBase Vision M2 franking machine by attachments such as
the weighing platform and display. It is best to transport the PostBase Vision M2
with both hands underneath the housing.
• If the PostBase Vision M2 franking machine has previously been in a cold environ-
ment (i.e. below 10 °C / 50 °F): Unpack the PostBase Vision M2 and wait at least
two hours before connecting and operating the PostBase Vision M2. The franking
machine needs this time to adapt to the environmental conditions allowing any con-
densed moisture to escape.
• If the PostBase Vision M2 develops strong odours, fumes or unusual noises,
immediately unplug the power plug from the outlet.
• Only have maintenance and repair work carried out by qualified personnel
approved by FP. Otherwise any warranty claims may become void.
5
For your safety