FP PostBase Vision M2 Installation And Safety page 12

Hide thumbs Also See for PostBase Vision M2:

Table of Contents

PostBase Vision M2

Connectivity settings

Default settings for an Ethernet connection

are stored for connecting to the FP infrastruc-

ture. Establishing the connection should run

seamlessly with these settings.

To test the connection to the FP infrastruc-

ture with this default setting:

• Tap the 'Continue' button.

If no connection is established, the 'Connec-

tivity Settings' must be adjusted:

• Tap 'Change' to open the wizard for setting

up the network connection.

• First select the desired connection type.

• Confirm the selection and continue with the

'Continue' button.

• Set the appropriate parameters for the net-

work step by step. If necessary, ask your

network administrator.

The 'Connectivity Settings' overview in the

reference guide shows and explains the pos-

sible settings.

Caution! During the further course of instal-

lation, the PostBase Vision M2 may start up

multiple times. Do not disconnect the

PostBase Vision M2 from the power supply.

Table of Contents

Need help?

Do you have a question about the PostBase Vision M2 and is the answer not in the manual?