Before First Use-Important - Insignia MX1818 Series Installation Manual

Table of Contents

Advertisement

www.insigniashowers.com
BEFORE FIRST USE — IMPORTANT

Ensure the rocks have been thoroughly washed before loading in to the heater.

Ensure you place the rocks loosely between the heating elements.

Don't over fill the heater, ensure sufficient airflow can be achieved for maximum output.

START UP! It's recommended that you heat the rocks thoroughly and leave the sauna door
closed for a period of 20-25 minutes. The rocks being new may split or spit under the heat
as they settle in. This is normal, but we recommend you don't sit in the cabin until you have
run the heat through the rocks and they have settled in. You may want to turn the heater
off and perform this a second time (when the rocks have cooled down) to be 100% certain
they have settled in.

It's recommended that the rocks are replaced annually and only use approved Sauna rocks,
NEVER use any other type of rock.

Never touch the rocks when they are fully heated.

Pour a ladle of water over the rocks approx. every 5 minutes to increase the air
temperature.

Pouring too much water on the rocks will lower the room temperature as they will cause
the rocks to cool down.

Never leave the Sauna unattended.
10.
Children should not use the Sauna unsupervised.
Last Modified: 20/12/2023
23

Advertisement

Table of Contents
loading

Table of Contents