Lincoln Electric LN-25 PRO DUAL POWER Service Manual page 84

F-34
FRONT PANEL REMOVAL AND REPLACEMENT PROCEDURE (continued)
PHILLIPS HEAD
SCREW
REMOVAL PROCEDURE
1. Remove the input power from the LN-25™ PRO
DUAL POWER unit.
2. Perform Case Cover And Control Box
Removal Procedure.
3. Remove the two phillips head screws and one
5/16" nut that hold the front panel and lift it out.
See Figure F.13.
4. Label and disconnect the molex plugs from the
control harness. See Wiring Diagram.
5. Disconnect the work lead and set it aside to use
with the new panel.
TROUBLESHOOTING AND REPAIR
FIGURE F.13 – FRONT PANEL
LN-25™ PRO DUAL POWER
5/16" NUT
REPLACEMENT PROCEDURE
1. Connect the work lead that was previously
removed.
2. Reconnect the molex plugs.
3. Slide the front panel into the control box and
attach it using the two phillips head screws and
one 5/16" nut.
4. Perform Case Cover And Control Box
Replacement Procedure.
F-34
PHILLIPS HEAD
SCREW