Lincoln Electric LN-25 PRO DUAL POWER Service Manual page 77

F-27
REMOVAL AND REPLACEMENT PROCEDURE (continued)
CONTROL BOX
ASSEMBLY
REPLACEMENT PROCEDURE
1. Slide control box assembly back into case
cover. See Figure F.10.
2. Tighten cord grip connector, located on the rear
of unit. See Figure F.9.
3. Using a 3/8" nutdriver attach control box
assembly to case cover using the eight screws
previously removed. See Figure F.9.
4. Close case cover side.
TROUBLESHOOTING AND REPAIR
CASE COVER AND CONTROL BOX
FIGURE F.10 – CONTROL BOX ASSEMBLY REMOVAL
LN-25™ PRO DUAL POWER
F-27
CASE COVER