Lincoln Electric LN-25 PRO DUAL POWER Service Manual page 76

F-26
REMOVAL AND REPLACEMENT PROCEDURE (continued)
FIGURE F.9 – CASE COVER SCREWS AND CORD GRIP CONNECTOR LOCATIONS
CORD GRIP
CONNECTOR
REMOVAL PROCEDURE
1. Remove input power from the LN-25™ PRO
DUAL POWER unit.
2. Using a 3/8" nutdriver remove the eight case
cover screws (two screws on top, four on left
side and two on bottom of unit). See Figure F.9.
3. Loosen the cord grip connector, located on the
rear of the unit. See Figure F.9.
4. Open the case side of machine.
5. Slide the control box assembly out of the case.
See Figure F.10.
TROUBLESHOOTING AND REPAIR
CASE COVER AND CONTROL BOX
LN-25™ PRO DUAL POWER
CASE COVER
SCREWS (8)
F-26