Table of Contents
Advertisement
1
12
It is advisable to tighten the junctions by insulating teflon
tape.
And if there is gas leak happens during using, please
immediately shut off the gas source or call local gas
sector service for help.
If the hob is to be combined with an oven, please check,
that gas intake connection of the appliance has a "male
thread"
When making the connection, take care not to apply
stresses of any kind to the appliance.
CONVERSION TO A DIFFERENT TYPE OF GAS
Before converting the appliance for operation with a
different gas type, check which type of gas it is currently
set to operate with (adhesive label on appliance).
For the correct nozzle diameter, refer to the relative table
in this booklet.
Conversion to a different gas type must be carried out
by qualified technicians and in conformance with the
requirements.
2
Conversion procedure:
3
•
Disconnect the electrical power supply to the
appliance,
•
Turn the knobs in the null position.
•
Replace the nozzles 1 with the corresponding
type of gas to be used (see table «Nozzle
table»).
•
To adjust to the minimum, light the fire und turn
the knob 2 in the position of minimal flame, then
remove the knob of gas submission.
•
Use a screwdriver on the screw placed on the tap
3.
•
For LPG (butane/propane) screw tight the tap.
EN
Advertisement
Table of Contents
