Advertisement
HARDWARE LIST
Installing WirelessAir
2
Item Part #
Description ................................................................................................Qty
A
73006
Wireless controller ............................................................................................... 1
B
72710
Wireless manifold ................................................................................................ 1
C
16192
Compressor ........................................................................................................ 1
D
20946
Air line (1/4") ..................................................................................................... 25 ft.
E
26897
Wiring harness .................................................................................................... 1
Hardware Pack
F
21838
Tee 1/4" PTC ...................................................................................................... 2
G
24652
ATC fuse, spade 15A........................................................................................... 1
H
24752
Heat shrink butt splice (10-12GA) ....................................................................... 2
I
24500
Fuse holder ATC/ATO .......................................................................................... 1
J
10466
8" Zip tie ............................................................................................................. 15
K
24748
3/8" Ring terminal (10-12GA) .............................................................................. 1
L
17524
1/4"-14 x 1 1/4" Screw, self-tapping zinc ........................................................... 4
M
24661
Heat shrink butt splice (14-16GA) ....................................................................... 1
N
24681
3/8" Ring terminal (14-16GA) .............................................................................. 1
SUGGESTED COMPONENT LAYOUT
This guide should be used as a general reference. The layout may need modification
based on the application.
• Avoid routing air lines and wiring near sharp edges. If passing air lines or wiring
through holes in the frame, use rubber grommets (not supplied). Support wiring and
air lines every 8-12" (203-305mm) with zip ties or other means.
• Keep wiring and air lines, manifold and compressor at least 6" (152mm) away from
heat sources such as the exhaust.
• Manifold and compressor should be no more than 16" (406mm) apart.
MOUNT THE
COMPRESSOR
1. The compressor can be
mounted in any orientation.
CAUTION
BEFORE DRILLING, ENSURE
THAT THE BACK SIDE IS CLEAR
OF VEHICLE COMPONENTS,
INCLUDING BRAKE LINES, FUEL
LINES, AND WIRING.
2. Use the compressor as a template and
mount with the hardware included with the
compressor. Use 1/4" drill bit for through bolts
or 3/16" pilot for self-tapping screws.
3. The compressor ground wire must be connected
to the harness (Fig. 2). It cannot be grounded to the
chassis.
4. Remote mount the compressor inlet filter using the hose
and fittings included with the compressor. Install in a dry
location shielded from direct splash. Ensure that the filter is
mounted pointed up with the hose routed down (Fig. 1).
Fig. 1
MN-1092
Advertisement
