Advertisement
WIRING AND AIR LINE CONNECTIONS
1. Route and install an air line (D) from port 1 of the manifold to the driver's (left) side air
2. Cut off the terminals on the red and black compressor wires and connect to the short
3. Connect the wiring harness (E) to the manifold (B) (Fig. 2). Press the connector on
FINAL STEPS: MOBILE APP/CONTROLLER PAIRING
For details on pairing your supported Apple
(Fig. 6) or Android (Fig. 7) device, or Wireless
controller (Fig. 8), please refer to your User
Guide (AD-963) included with your kit.
MN-1092
spring. Route and install an air line (D) from port 2 of the manifold to the passenger's
(right) side air spring (Fig. 2). Install tee fittings (F) and Schrader valves if manual
inflation is desired (Fig. 2). Route and install an air line (D) from port C of the manifold
to the compressor (C) PTC fitting. To ensure a proper and clean cut, see Cutting the
Air Lines.
red and black wires on the wiring harness (E) using butt splices (H) (Fig. 2). The ground
wire cannot be grounded to the chassis and must be connected to the harness. Route
the harness (E) along the frame and make all wiring connections (Fig. 2). Finish by
connecting the wiring to the battery. Wait to install the fuse.
completely and listen for an audible "click". Ensure a proper drip loop exists to
prevent water intrusion (Fig. 5). Install the fuse (G) last. The system will automatically
fill to 5 PSI (.34BAR) once the fuse is installed.
Fig. 6
Scan the QR code
to view a short video
demonstrating how
to complete mobile
app pairing.
Fig. 7
WirelessAir
Fig. 5
Fig. 8
5
Advertisement
