Table of Contents
Advertisement
Memory
The SBI-6429P-C3N SuperBlade module has twenty-four (24) 288-pin DIMM sockets
that can support up to 3 TB of RDIMM/LRDIMM DDR4 2666/2400 MHz speed, 8 GB, 16
GB, 32 GB, 64 GB and 128 GB size memory per node. Memory is interleaved, which
requires modules of the same size and speed to be installed in groups (of two or three).
Please refer to the Supermicro website for a list of supported memory
(www.supermicro.com/products/superblade). The detailed specifications for a blade
module will contain a link to a list of recommended memory sizes and manufacturers.
Details on installation of memory modules into the SBI-6429P-C3N SuperBlade module
are found in
Chapter 3: "Setup and Installation" on page
Storage
The SBI-6429P-C3N SuperBlade module has three HDDs in front-mounted easily
removable hot-swap carriers. These can either be configured for two NVMe and one
SAS3/SATA3 2.5" drives or three SAS3/SATA3 2.5" drives.
See
Chapter 3: "Setup and Installation" on page 3-1
RAID
Each SBI-6429P-C3N blade module supports several hard drives, which may create a
RAID system for the blade module. The SBI-6429P-C3N has a Broadcom 3108 SAS
RAID chip for RAID 0, 1, and 5.
Further information on the RAID and its software can be found on our website at:
http://www.supermicro.com/manuals/other/
LSI_2108_2208_SAS_MegaRAID_Configuration_Utility.pdf
Enclosure Requirements
The SBI-6429P-C3N blade module requires one of the following enclosures to run in:
•
SBE-614E-822
•
SBE-614E-622
•
SBE-614E-422
•
SBE-614EB-422
The SBI-6429P-C3N blade module also requires a power supply in the enclosure to run
the blade module. Available SuperBlade power supplies can be found on the
Supermicro website at
powersupply/.
42https://www.supermicro.com/products/SuperBlade/
1-3
Chapter 1: Introduction
3-1.
for storage installation details.
Advertisement
Table of Contents
