Advertisement
Quick Links
Materials and Surface Finish
Part
Surface materials
Worktop
Core material
Edge material
Leg
Desk/Table
Center Rail
Bench Double
Modesty
Panel
Single
Beam
Wiring Duct
Surface materials
Wiring Cover
Body
Surface materials
Flont/
Panel
Side/
Core material
End
Upper
Monitor Stand
Main body
＊
Please understand that product specifi cations might change without prior notifi cation due to
improvements made to the product.
Materials
Surface Finish
High Pressure Laminate
-
Steel
-
ABS
-
Steel
Bake coating
Steel
Bake coating
Felt
-
Steel
Bake coating
Steel
Bake coating
Steel
Bake coating
AL(Alminium)
-
ABS
-
Polyester
-
Steel
-
Acrylic
-
Steel
Bake coating
GXL001／2024-03
Office System
【Bench ・ Desk ・ Table ・ Option】
Instructions for Use
Advertisement
Related Manuals for Okamura Workflex
Summary of Contents for Okamura Workflex
- Page 1 Materials and Surface Finish Part Materials Surface Finish Office System Surface materials High Pressure Laminate Worktop Core material Steel Edge material Steel Bake coating Desk/Table Center Rail Steel Bake coating Bench Double Felt Modesty Panel Single Steel Bake coating 【Bench ・ Desk ・ Table ・ Option】 Beam Steel Bake coating...
- Page 2 Please follow instructions below. Failure may cause serious damage to the connected. Failure may cause equipment to proof. Do not keep any valuables in the product and Okamura will have no responsibility for any damages. be disconnected or overturned. product.
- Page 3 Parts Name Operation Guide ■Tabletop Height Adjustment ■ Bench （Top up/top down） Desktop panel Acrylic Panel The tabletop height can be adjusted by turning the leveler under the legs Wiring Cover legs in the range of 0 to 15 mm.When End Panel placing the product, be sure to level the tabletop by the leveler.
- Page 4 ■Wiring Cover Please follow instructions below. Failure may cause serious damage to the product and Okamura will have no responsibility for any damages. Open/close the Flip Lid while holding its front part. Open the Flip Lid (turn it to lift) to access the cables, OA tap, etc.
Need help?
Do you have a question about the Workflex and is the answer not in the manual?
Questions and answers