Table of Contents
Advertisement
Quick Links
DESK
865XTW
Assembly/Instruction Manual
Important Document
Thank you for purchasing an Okamura
Study DESK. Carefully read and
understand the contents of this
Assembly/Instruction Manual to ensure
proper assembly and use.
Warning label
(attached to the
desktop surface)
Product serial number sticker
(attached to the shelf bottom
support panel, the desktop shelf
rear panel)
Assembly indicator label
(attached to the shelf bottom
support panel)
Assembly indicator label
(attached to the inner panel)
A cross-head screwdriver is required for
assembly. Have one ready before you begin.
* Do not use an electric screwdriver for
assembly, as it could damage the product.
Desktop
Drawer
Outer
panel
Quality label
(attached to the
Inner
shelf bottom
panel
support panel)
Combination Example of Desk and Desk Wagon
Diagram of assembled wagon
Fixed shelf
At least two
people should
work together to
assemble the
desk.
(names of parts)
Movable shelf
Small drawer
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Okamura 865XTW
Summary of Contents for Okamura 865XTW
- Page 1 Diagram of assembled wagon (names of parts) Fixed shelf Desktop shelf Movable shelf Small drawer Thank you for purchasing an Okamura Study DESK. Carefully read and understand the contents of this Assembly/Instruction Manual to ensure proper assembly and use. Desktop...
- Page 2 For Your Safety (Please observe the safety precautions) This denotes information about a potentially hazardous situation that may result in Warning death or serious injury if the warning is ignored or the product is used improperly. Caution This denotes information about a situation that may result in injury or physical damage if the caution is ignored or the product is used improperly.
- Page 3 Caution Installation precautions Position the product on a level, stable surface. Make sure that at least two people lift and carry If you use the product on an inclined or the desk when installing or moving it. If you unstable floor, it may cause the product to fall slide the desk, it may scratch the floor.
- Page 4 Desk Parts list Point (Make sure to check the information below before you start assembling.) (Note about screw-type connectors) Screw-type connector Screw-type connector Connecting bolt Actual size Ring (Embedded in various parts) Turn clockwise to tighten. Arrow Turn counter-clockwise to loosen. When the arrow is aligned Single-end Bag hook...
- Page 5 Mounting the Outer Panel Mounting the Shelf Bottom Support Panel Left outer panel Mount the shelf bottom support panel to the rear Mount the part assembled in step panel, and firmly tighten the screw-type connectors. 2 to the right outer panel, and firmly tighten the screw-type * Mount so that the Shelf bottom...
- Page 6 Desk Assembly Check Mounting the Inner Panel Insert the ring into the inner panel that was aligned in step 6, and Flip the assembled desk to its proper position, and firmly tighten the connecting bolts at check that the desk has no looseness and that the Next, align the left-side height as shown bolts are firmly tightened.
- Page 7 When Removing a Drawer Fitting the 3-drawer Wagon Unit If the desktop panel is a height of JIS2 or JIS3, then the top drawer unit of the To remove a drawer, remove the desk wagon must be separated. The separated unit can be mounted to the rear screws from the inside of the drawer as shown in the figure.
-
Page 8: Troubleshooting
Okamura Corporation International Sales and Marketing Div. 9F Kokusai-Shin Akasaka Bldg. East, 2-14-27 Akasaka Minato-ku, Tokyo 107-0052 Japan http://www.okamura.co.jp...
Need help?
Do you have a question about the 865XTW and is the answer not in the manual?
Questions and answers