Okamura Contessa Instructions For Use Manual
  1. Manuals
  2. Brands
  3. Okamura Manuals
  4. Indoor Furnishing
  5. Contessa
  6. Instructions for use manual

Okamura Contessa Instructions For Use Manual

Ergonomic mesh chair
Hide thumbs Also See for Contessa:

Advertisement

Table of Contents

Enlarged version
OKAMURA CORPORATION
INTERNATIONAL SALES & MARKETING DIVISION
2-14-27, Akasaka, Minato-ku, Tokyo 107-0052, JAPAN
Tel : +81-3-5561-4085
Fax : +81-3-5561-4086
//
.
/
http:
www
okamura.jp
E r g o n o m i c
I n s t r u c t i o n s f o r U s e
G1A784
2018-04
M e s h
C h a i r

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Contessa and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Okamura Contessa

Summary of Contents for Okamura Contessa

  • Page 1 M e s h C h a i r I n s t r u c t i o n s f o r U s e OKAMURA CORPORATION INTERNATIONAL SALES & MARKETING DIVISION 2-14-27, Akasaka, Minato-ku, Tokyo 107-0052, JAPAN...
  • Page 2 Also, make sure that the arms are fixed tightly before use.  Do not disassemble or repair on your own. Please contact our official dealers when needed.  No remodeling. Okamura will have no responsibility for any disadvantage caused by remodeling.

  • Page 3: Installation

    Installation Please follow instructions below. Failure may cause serious damage to the product. Avoid high temperature, high humidity, or extraordinary aridity. Indoor use only. Do not place product under heater or air-conditioner exhausting high temperature air. No outdoor or waterfront use. For maintenance ...

  • Page 4: Part Names

    Part names Adjustable range  Headrest type Large headrest Small headrest (option) (option) 75mm (2 3/4”) Backrest Adjustable arm Backrest frame 40° Seat height adjustment lever Seat Reclining tension control dial Gas lift Caster  Standard type Fixed arm Adjustable arm Lumbar support 50mm (2”)
  • Page 5 Operation guide Seat height adjustment Seat depth adjustment Adjust the seat height using the seat height adjustment Adjust the seat depth by sliding the seat forward lever at the front of the right armrest. The seat will be or back within a range of 50 mm (2”) using the lowered if you lift the lever while seated, and it will stop seat slide lever underneath the seat.
  • Page 6 Operation guide Reclining adjustment If you turn the dial in the [A] Reclining tension adjustment direction (counterclockwise) Adjust the backrest recline by using the reclining Adjust the reclining tension by using the reclining as shown in the illustration on control lever at the front of the left armrest. Click the tension control dial under right side of the seat.
  • Page 7 Operation guide Adjustable armrest Lumbar Support Adjusting height and angle. Adjusting height and longitudinal position. Lift the ratchet-type adjustable arm up for optional To adjust the height of the lumbar support behind adjustment. To return the arm to the lowest position, the backrest, hold the tabs and lift up and down lift up the arm to the highest position.
  • Page 8 Operation guide Materials Adjustable Small Headrest Adjusting height, longitudinal position, and Part Materials inclination. Backrest Metal (aluminum) >ADC< The height, front and rear positions, and angles of 75mm Body Frame Glass reinforced polyamide >PA-GF< the small headrest are adjustable. Operate slowly (2 3/4”) while holding the headrest part.

  • Page 9: Troubleshooting

    Troubleshooting Problem Check Solution Page Problem Check Solution Page Are you sitting on the seat when Adjust the seat height while not The arm cannot Lift up the arm to the highest position The seat adjusting the seat height? seated on the seat. be lowered.
  • Page 10 Memo...

Table of Contents

Save PDF