Advertisement
TTB949MLT by TITAN
Transportation
1. Switch the product off and disconnect it from the power supply.
2. Attach transportation guards, if applicable.
3. Always carry the product by its grip handle (4 / 12).
4. Protect the product from any heavy impact or strong vibrations which may
occur during transportation in vehicles.
5. Secure the product to prevent it from slipping or falling over.
Troubleshooting
Therefore check the product using this section. In most cases the problem can
be solved quickly.
WARNING! Only perform the steps described within these instructions!
All further inspection, maintenance and repair work must be performed
cannot solve the problem yourself!
Problem
1. Product
1.1. Not connected to power
does not
start
1.2. Power cord or plug is
1.3. Other electrical defect to the
2. Product
does not
reach full
2.2. Power source (e. g.
power
2.3. Air vents are blocked
3. Unsatis-
3.1. Grinding / cutting wheel /
factory
working
3.2. Grinding / cutting wheel /
result
4.
4.1. Grinding wheel / cutting wheel
vibration
or noise
4.2. Bolts/nuts are loosen
Care and maintenance / Troubleshooting
Possible cause
supply
defective
product
operation with this product
generator) has too low voltage
drilling bit is dull/damaged
drilling bit is not suitable for
workpiece material
/ drilling bit is dull/damaged
Solution
1.1. Connect to power
supply
1.2. Check by a specialist
electrician
1.3. Check by a specialist
electrician
2.1. Use a proper
extension cord
2.2. Connect to another
power source
2.3. Clean the air vents
3.1. Replace with new
one
3.2. Use proper grinding
/ cutting wheel /
drilling bit
4.1. Replace with a new
one
4.2. Tighten bolts/nuts
EN
EN
39
Advertisement
