Table of Contents
Advertisement
80
~-------------------------------------------------------------
Jumper Plug Table
Plug No.
Position of jumper plug
Side A
Side
B
Sl
Character code ASCII
Character code JIS
S2
ON LINE
OFF LINE (Local test on)
S3
Fixed on Side A
S4
NOT AUTO LF
AUTO LF
Note:
1)
NOT AUTO LF:
On receipt of 80-character data, prints
but does not paper feed a line.
S
S2
S4
AUTO LF:
On receipt of 80-character data, prints and
paper feeds a line.
2)
If the numeral "3" is engraved immediately after the
name "LEPU", the character code JIS applies to side A
and character code ASCII to side B.
3)
All jumper plugs are positioned on side A when shipped
from the factory.
Adjust their locations according to
requirements by using the jumper plug table.
Inserting
Function
Side
A
On line:
For applying inputs from interface line
B
Local test:
If/hen PRINT switch is pushed to ON position
with S2 at this position, printer prints all
characters continuously.
Set PRINT switch
to OFF to stop printer.
Caution
l.
Avoid continuous printing for a long
time because
i t
will raise temperature
and shorten life.
2.
Keep interface cord unplugged.
A
Automatic line spacing function cut out:
I f
CR code is received, or if more than 80
characters are received, printer prints and
then only returns carriage.
Paper is moved up one line only when LF code
is received.
B
Automatic line spacing function:
If CR code is received, or if more than 80
characters are received, printer prints and
then automatically returns carriage and
moves paper up one line.
Advertisement
Table of Contents
