Table of Contents
Advertisement
~-----------------------------------------------------------
20
3.3.2
Fixed Sprocket Paper Loading Procedure (See Fig. 3-6)
(1)
Turn off the printer power and remove the top plastic
cover.
(2)
Tilt the paper lock release lever forward (released).
(3)
Open the paper guide wire and the paper cut knife.
(4)
Thread the paper through the paper chute and separate,
and align the sprocket holes of the paper to the sprocket
pins.
(5)
Feed the paper by turning the knobs of the platen.
(6)
Close the paper cut-knife and paperguide wire.
Replace
the top plastic cover.
(Leave the paper lock release
lever forward).
NOTE
1)
When using fixed sprocket paper, keep the paper lock release
lever in the release (forward) position.
2)
When using fixed sprocket paper, remove the roll paper
holder.
3.3.3
Fixed Sprocket Paper Loading Procedure (in case of using variable tractor
unit)
(See Fig. 3-7.)
(1)
Turn off the printer power.
(2 )
Lift and remove the top plastic cover.
on both sides).
(Pulling evenly
(3)
Tilt the paper lock release lever forward (release position).
(4)
Place the paper guide wire, and the paper cut-knife in the
open position.
(5)
Open the sheet feeder cover.
(6)
Thread the paper between the paper chute and the paper
separator, and locate the sprocket holes of the paper onto
the tractor pins.
(7)
Close the sheet feeder cover.
(8)
Relocate the paper cut-knife, the paper guide wire, and the
top cover to their original positions.
(9 )
Turn the
feed the
turn the
aligned.
platen knob to align the first line.
That is,
paper up a little more than necessary, and then
knob back to run the paper backward until it is
Then, pull the paper back to eliminate slackness.
Advertisement
Table of Contents
