Table of Contents
Advertisement
~-----------------------------------------------------------
56
(3)
Printer Unit (See Figs. 7-2, 7-8.)
Item
Dis-
assembly
Re-
assembly
Sketch
Description
Remove upper cover.
(See
5. 5 . 4 (1).)
Pullout print head connector.
CD
Remove flat cable connector screw
from carriage frame, and take
connector out from carriage frame.
GD
Cut tie-wrap which fastens flat
cable.
CD
Loosen Quite-tight screw (Fig. 7-8-26)
which fastens printer unit
(Fig. 7-2) until Quite-tight
(Fig. 7-8-10) no longer has swell.
®
Remove circuit board screw (Fig. 7-8-
23), raise circuit board, and pullout
all connectors which connect circuit
board to printer unit.
CD
Hold right and left side plates of
printer unit, lift printer unit and
remove it from Quite-tight
Reassemble by reversing above order.
Note: 1) Tighten printer unit Quite-tight
screw at a tightening torque of
4 to 5 kg.cm.
2) When connecting the flat cable
fix it when it is flush with the
end face of the base frame, pro-
vided that the carriage is at the
left end.
l
Lower cove
rl
I
t.
'J
I
Screw
Tool
No. 2-200
Philips
screwdriver
No. 2-200
Philips
screwdriver
No.
5H
nippers
No. 2-200
Philips
screwdriver
No. 2-200
Philips
screwdriver
Advertisement
Table of Contents
