Table of Contents
Advertisement
----------------------------------------------------------~
(9)
Platen (See Figs. 7-3 and 7-4.)
Item
Dis-
assembly
Reas-
sembly
Adjust-
ment
Description
Remove the upper cover.
(See 5.5.4 (1).)
(]) Remove the detent spring (Fig 7-3-20).
CD
Remove one of the E-snaps (Fig. 7-3-28),
pull the cut knife lever shaft
®
®
(Fig. 7-3-21) from the side plate, and
remove the paper cut knife (Fig. 7-3-
17) .
Note:
Be careful not to lose the collar
(Fig. 7-3-27)
located between
right and left side plates and
paper cut knife.
Remove the paper separator screw
(Fig. 7-3-33), and then the paper
separator (Fig. 7-3-16).
Remove the E-snap (Fig. 7-3-31), and
then the idle gear (Fig. 7-3-8).
Pull the ri0ht and left plate bearings
horizontally (Fig. 7-4-2) until their
projections come off side plates,
turn 90°, and remove platen by lifting
it.
Reverse the disassembly procedure.
Clearance between the paper separator and
the platen
Platen
Paper separator
Install the paper separator and the
platen after
s~curing
a clearance of
about 0.5 mm between them.
Tool
No. 2-200
Philips
screwdriver
No.
1
round
pinchers
No.
1
round
pinchers
No. 2-200
Philips
screwdriver
No. 1 round
pinchers
Thickness
gauge
63
Advertisement
Table of Contents
