Table of Contents
Advertisement
PROGRAM OVERRIDE
PROGRAM OVERRIDE
Example shows how to select a
temporary period in System Auto mode.
Note: The installer setup can limit the length
of time for an override to 1, 2, 3, or 4 hours
beyond the current time.
Override allows application of temporary set
Setpoint
for a
PRESS ANY KEY TO BEGIN
point setting. (Example uses System Auto.)
Press Override, or ▲/ ▼key.
1.
Note: Setpoint flashes. "Hold until" time
appears and is changed to show length
of override (up to the maximum hold
time specified in Service Menu 395).
2.
Press ▲/ ▼to select the Setpoint, then
press Next.
3.
Press ▲/ ▼to adjust time (in 15-minute
periods) until override remains in effect.
4.
Press Done to save changes and exit.
Note: Override remains (flashing) in
effect until the time period ends.
Note: Press Cancel to exit Override.
Advertisement
Table of Contents
