Advertisement
+h
SET
UP
**
SYNC
SHUTTER
CAMERA
ID
ELC
AGC
WHITE
BAL
END
AUC
(PUSH
SW)
Fig. 56
Note:
The Gain Up operation under the Direct Mode is
disabled when ELC is ON mode.
Press the Setup Mode Button (SET UP) to proceed to
the Backlight compensation menu as shown in Fig. 57.
4%
ELC
ON
a
BACKLIGHT
COMP
PRESET
OFF 4m
MANUAL SET
LEVEL.
RET
END
Fig. 57
6-2-1. ELC ON Mode with Preset Mode (PRESET ON)
Move the cursor to the "PRESET" mode position and
select the "ON" mode by using the Left Button (WHT
BAL) or Right Button (GAIN UP). The preset mode menu
is displayed on the monitor screen as shown in Fig. 58.
»* ELC ON
**
BACKLIGHT
COMP
PRESET
cn @
RET
END
Fig. 58
Move the cursor'to "RET" position by using the Up
Button (AGC) or Down Button (AWC SET) and press the
Setup Mode Button (SET UP} to return to the Setup
menu.
Note:
Move the cursor to the "END" position and press
the Setup Mode Button (SET UP) to return to the
normal camera picture mode.
6-2-2. ELC ON Mode with Field Setup Mode
(PRESET OFF)
e
Move the cursor to the "PRESET" mode position and
select the "OFF" mode by using the Left Button (WHT
BAL) and Right Button (GAIN UP}.
e
The field setup menu is displayed on the monitor screen
as shown in Fig. 59.
-20-
BACKLIGHT COMP
PRESET
MANUAL
SET
LEVEL
RET
END
OFF, 4m
Fig. 59
Move the cursor to the "MANUAL SET" mode position
and press the Setup Mode Button (SET UP). The 25
Mask Areas appears on the monitor screen as shown
in Fig. 60. The left top area starts blinking as a cursor.
Press the
Setup Mode Button
(SET UP)
Blinking
*k ELC
ON
Hok
BACKLIGHT
COMP
PRESET
OFF
MANUAL SET; 4m
LEVEL
RET
END
Fig. 60
To mask this area, press the Setup Mode Button (SET
UP}. The word "MASK" appears in this area as shown
in Fig. 61.
Blinking ~
See:
TNA
ee
at
ASE
Seal
Ao
aE
HE
pe
rN IEE EEN,
FeS
TEN
Ae
Fig. 61
EER
'oe
.8
ots
BOY
see
pim:
o?
be se:
To mask other areas, move the cursor to the desired
area by using the Up Button (AGC), Down Button (AWC
SET), Left Button (WHT BAL) or Right Button (GAIN UP).
The previous masked area then stops blinking and turns
to white as shown in Fig. 62.
Turned to white ——
Blinking —
Fig. 62
When
the
cursor
is moved
to
the
area
where
has already been masked
before, the word "MASK"
appears.
Press
the Setup Mode
Button (SET UP) when
this
masking is to be canceled.
Advertisement
