Advertisement
No more setting up or adjustment is required.
5-7-2. Automatic White Balance Control Mode (AWC)
e
Move the cursor to the "WHITE
BAL" mode
position
and select the "AWC" mode by pressing the Left Button
e
(WHT BAL) or Right Button (GAIN UP}. "(PUSH SW)' is
e
now displayed.
#* SET UP ok
SYNC
6.
SHUTTER
CAMERA 10
ELC
AGC
WHITE BAL
AUC
6-1
(PUSH SU)
END
m
Fig. 44
e
Press the Setup Mode Button (SET UP) to setup the
white balance. The "(PUSH SW)" display starts blinking
to indicate that the white balance is being set.
wk SET UP tk
SYNC
SHUTTER
CAMERA
ID
ELC
INT
OFF
OFF
OFF
ON
AWC
(PUSH=Sw | Gas
AGC
WHITE
BAL
END
Fig. 45
e
When
the white
balance
setting is completed,
the
blinking "(PUSH SW)" stops.
5-7-3. Manual White Balance Mode (MANU)
@
Move the cursor to the "WHITE BAL" mode position and
select the "MANU" mode by pressing the Left Button
{WHT BAL) or Right Button (GAIN UP). "MANU" is now
displayed.
+e SET UP **+
SYNC
SHUTTER
CAMERA
I
o
e
=> NAND
(PUSH SW)
AGC
WHITE BAL
END
Fig. 46
è
Press
the
Setup
Button
(SET
UP) to display
the
following gain adjustment menu on the screen.
+k WHITE
BAL +*
R-GAIN
RET END
Fig. 47
- 18-
The cursor on the "R-GAIN" position is blinking.
Keep pressing the Left Button (WHT BAL) or the Right
Button (GAIN UP) to obtain an optimum Red gain. The
cursor "|" moves to right or teft.
Move the cursor to the "B-GAIN" position.
Keep pressing the Left Button (WHT BAL) or the Right
Button (GAIN UP} to obtain an optimum Blue gain. The
cursor "I" moves to right or left.
BACKLIGHT COMPENSATION
(BACKLIGHT COMP)
. ELC OFF Mode
Confirm that the ELC mode is selected as follows.
Display the Setup menu as shown in Fig. 20.
Move the cursor to the "ELC" mode position and select
the "OFF" mode by using the Left Button (WHT BAL) or
Right Button (GAIN UP).
ae
SET
UP tn
INT
OFF
OFF
OFF:
ON
=
AUC
(PUSH
$W)
SYNC
SHUTTER
CAMERA
10
ELC
AGC
WHITE
BAL
END
Fig. 48
Press the Setup Mode Button (SET UP) to proceed to
the Backlight compensation menu as shown in Fig. 49.
x
ELC
OFF
+
BACKLIGHT
COHP
PRESET
mb OFF;
MANUAL SET
LEVEL
RET
END
Fig. 49
6-1-1, ELC OFF Mode with Preset Mode (PRESET ON)
Move the cursor to the "PRESET" mode position and
select the "ON" mode by using the. Left Button (WHT
BAL) or Right Button (GAIN UP). The preset mode menu
is displayed on the monitor screen as shown in Fig. 50.
wk
ELC
OFF
+e
BACKLIGHT
COMP
PRESET
= oN
RET
END
Fig. 50
Advertisement
