Advertisement
Caution:
e
If you want to return to the normal picture mode, move
The
backlight
compensation
setting
allocated
the cursor to the END position. Then press the Setup
under
this menu
is described
in the section 6
Mode Button (SET UP). However, if you want to set up of
and this setting should be done after installing
the AGC OFF mode, proceed the following procedures.
the camera to the site and observing the actual
èe
Move the cursor to RET position and press the Setup
site picture.
Mode Button (SET UP) to display the Setup Menu.
e
AGC ON is blinking in the Setup Menu. Change the ON
5-4, Shutter Speed Setting (SHUTTER)
to OFF by pressing the Left Button (WHT BAL) or the
è
Display the Setup menu as shown in Fig. 20.
Right Button (GAIN UP). Then press the Setup Mode
e
Move the cursor to the SHUTTER mode position and
Button (SET UP) to display AGC OFF menu as shown in
select the electronic shutter speed by pressing the Left
Fig. 32.
Button (WHT BAL) and the Right Button (GAIN UP).
AGC OFF
+k SET UP tom
we
SYNC
INT
Sure | See
ELCs
"
grr
GATE BAL
AWC
RET END
(PUSH SW)
END
Fig. 32
Fig. 30
e
Press the Left Button (WHT BAL) or the Right Button
The following electronic shutter speed is available.
(GAIN UP) to select the Gain.
The Gain changes as
follows.
OFF (1/60) — 1/100 — 1/250 — 1/500 —
| 1/1000 — 1/2000 > 1/4000 — 1/10000 Eaa
c OFF > LOW > MID — HI 7
5-5. Gain Control Setting (AGC ON/OFF)
5-6. Synchronization Setting (SYNC)
è
Display the Setup menu as shown in Fig. 20.
e
Display the Setup menu as shown in Fig. 20.
e Move the cursor to the AGC mode position and select
èe Move the cursor to the SYNC mode position.
either ON or OFF mode by using the Left Button (WHT
BAL) and Right Button (GAIN UP).
e
When the ON mode is selected and the Setup Mode
++ SET UP +
Button (SET UP} is pressed, the "HI" is displayed as
SYNC ER
shown in Fig. 31.
CAMERA ID
ELC
AGC
WHITE BAL
AUC
(PUSH SW)
END
Fig. 33
RET END
Important Notice :
es
1, The pridrity of sync mode is as follows.
1. Color Composite Video Signal {VBS)
Fig. 31
2. B/W Composite Video Sync Signal (VS)
3. HD/VD Signal
èe
Press the Left Button (WHT BAL) or the Right Button
4. VD Signal
(GAIN UP) to select the AGC level. The level changes
5. Internal Sync (INT)
as follows.
2. When the internal sync mode is to be used, select the
INT position and no gen-lock input signal should be
3. When the VBS or VS gen-lock mode is to be used, and
Notes:
supply the gen-lock input signal to the Gen-iock Input
LOW is approximately +6 dB
Connector (11) on the rear panel.
MID is approximately +9 dB
HI is approximately +12 dB
~1§-
Advertisement
