5-2-3 Write Down Projector IP
1. Connect projector with PC by LAN cable.
2. Turn on the projector, then press "Menu"
button to get into OSD menu.
- Use "right" button to select "SETUP".
- Use "down" button to remove the light
mark to "Network Settings", then press
"Enter" button to select "LAN Setting",
press "Enter"button.
- Remove the light mark to "DHCP", then
press "Enter" button to select "Off", press
"Enter" button.
- The IP address will be shown on screen.
- Write down the IP address: 192.168.0.100.
- Select "Exit" to OSD.
3.Shut down the projector.
EK-600U/EK-601W
5-8