Configure The Srx345 Using The Cli - Juniper SRX345 Hardware Manual

• Bits per second—9600
• Parity—None
• Data bits—8
• Stop bits—1
• Flow control—None
7. If you have not already done so, power on the SRX345 by pressing the Power button on the front
panel. Verify that the PWR LED on the front panel turns green.
The terminal emulation screen on your management device displays the startup sequence. When the
SRX345 has finished starting up, a login prompt appears.

Configure the SRX345 Using the CLI

To configure the SRX345 by using the CLI:
1. Start the CLI.
root@%cli
root>
NOTE: You can view the factory-default settings by using the show configuration command.
2. Enter configuration mode.
configure
[edit]
root#
3. Set the root authentication password by entering a cleartext password, an encrypted password, or an
SSH public key string (DSA or RSA).
[edit]
root# set system root-authentication plain-text-password
password
New password:
Retype new password:
password
53