Installing The Srx345 Firewall Into A Rack - Juniper SRX345 Hardware Manual

Installing the SRX345 Firewall into a Rack

You can front-mount the SRX345 Firewall in a rack. Many types of racks are acceptable, including four-
post (telco) racks, enclosed cabinets, and open-frame racks.
NOTE: If you are installing multiple devices in one rack, install the lowest one first and proceed
upward in the rack.
To install the services gateway in a rack:
1. Position a mounting bracket on each side of the chassis.
2. Use a number-2 Phillips (+) screwdriver to install the screws that secure the mounting brackets to the
chassis. Use either the front mount position, as shown in
mount position, as shown in
Figure 10: Installing the Rack Mount Brackets (Front Mount Position)
Figure 11: Installing the Rack Mount Brackets (Center Mount Position)
3. Have one person grasp the sides of the services gateway, lift it, and position it in the rack.
4. Align the bottom hole in each mounting bracket with a hole in each rack rail, making sure the chassis
is level.
5. Have a second person install a mounting screw into each of the two aligned holes.
Figure 11 on page 37 .
Figure 10 on page 37 , or the center
37