ziva EasyVac Manual page 19

Method and operation
Prevent moisture from the bag from being sucked into the machine!
If moisture is absorbed, this can lead to damage outside the warranty. Hang the bag
over the work surface so that gravity helps or put the filled vacuum bag briefly in the
freezer before vacuuming so that any moisture becomes less liquid.
If any moisture ends up in the vacuum chamber, you must immediately press Stop and
remove the moisture in the vacuum chamber.
Vacuum chamber
Close the lid by pressing it firmly until both
closing hooks of the lid are in place (in which
case you will hear a click on both sides).
You can now start the vacuum or sealing
process.
Copyright © 2024 – Kenners bv, Nieuwveen, The Netherlands
Place the embossed vacuum bag with the
opening in the vacuum chamber between the
edges of the oval seal. You place the opening
over the rubber strip and first edge of the seal,
but not over the second edge of the oval seal. If
the opening is not in the vacuum chamber, the
bag will not vacuum.
Make sure the vacuum bag does not cover the
vacuum opening on the right side.
If necessary, adjust the device as desired with
the " Moisture " button. If your product is
damp, use the "Wet" setting. For dry products
use "Dry".
When the cycle or sealing is complete, firmly
press both buttons on either side of the
machine to unlock the lid. You can now remove
the vacuum-sealed bag from the machine.
18