Crown CT13587 Original Instructions Manual page 25

• Loosen lock nut 6�
• Rotate limit screw 5 to change the milling depth (un-
screwing limit screw 5 increases the milling depth)�
• Tighten lock nut 6�
• To achieve the maximum possible milling depth,
turn stepped stop 7 to the "max�" position (the notch
on stepped stop 7 is between positions "0" and "20")�
After setting the milling depth, it is recom-
mended to make a few test keyways to
make sure the setting is correct�
General recommendations for operation (see
fig. 7-13)
• For joining workpieces with dowels, it is recom-
mended to use the largest dowels that can fit into the
workpieces�
• Set the necessary milling depth as described above�
• Lay out the workpieces on a flat surface in the order
of the subsequent assembly�
• Mark the centers of the dowels as shown in fig-
ure 7�2� Recommended distances:
• from the workpiece edge to the center of the dow-
el it is 50-75 mm;
• between dowels it is 150-250 mm�
• Secure the workpieces�
• If necessary, adjust the tilt angle and the lift height of
angle / height stop 9�
• Place the power tool on the workpiece so
that mark 8 is at the center of the prospective
keyway�
• Holding the power tool by auxiliary handle 3, turn
it on and move the body forward� Do not move the
power tool sideways or upward, you will damage the
workpiece�
• Hold the power tool by auxiliary handle 3, turn it off
and return the body to its original position�
• Figures 8-13 show different types of dowel connec-
tions and how keyways can be milled to fit them. In
any case, it is advised to make a test milling on waste
pieces of material, then assemble them "dry" to make
sure that all settings are correct, and only then start
working with the workpieces�
The manufacturer reserves the possibility to introduce changes.
Power tool maintenance / preventive
measures
Before carrying out any works on the power tool it
must be disconnected from the mains.
Cleaning of the power tool
An indispensable condition for a safe long-term exploi-
tation of the power tool is to keep it clean� Regularly
flush the power tool with compressed air thought the
ventilation slots 4�
After-sales service and application service
Our after-sales service responds to your questions
concerning maintenance and repair of your product as
well as spare parts� Information about service centers,
parts diagrams and information about spare parts can
also be found under: www.crown-tools.com�
Transportation of the power tools
• Categorically not to drop any mechanical impact on
the packaging during transport�
• When unloading / loading is not allowed to use any
kind of technology that works on the principle of clamp-
ing packaging�
Environmental protection
Recycle raw materials instead of dispos-
ing as waste.
Power tool, accessories and packaging
should be sorted for environment - friendly
recycling�
The plastic components are labelled for categorized
recycling�
These instructions are printed on recycled paper man-
ufactured without chlorine�
English
25