Table of Contents
Advertisement
BODY PANEL REPLACEMENT
2.
MEASURING
(a) Basically, all measurements are to be done with a tracking
gauge. For portions where it is not possible to use a tracking
gauge, a tape measure should be used.
(b) Use only a tracking gauge that has no looseness in the body,
measuring plate, or pointers.
F10117A
HINT:
1.
The height of the left and right pointers must be equal.
2.
Always calibrate the tracking gauge before measuring
or after adjusting the pointer height.
3.
Take care not to drop the tracking gauge or otherwise
shock it.
4.
Confirm that the pointers are securely in the holes.
F10118A
(c) When using a tape measure, avoid twists and bends in the
tape.
(d) When tracking a diagonal measurement from the front
spring support inner hole to the suspension member upper
rear installation hole, measure along the front spring support
panel surface.
F10119A
BP-73
Advertisement
Table of Contents
