Table of Contents
Advertisement
BP-72
BODY PANEL REPLACEMENT
GENERAL INFORMATION
1.
BASIC DIMENSIONS
(a) There are two types of dimensions in the diagram.
(1) (Three-dimensional distance)
D
Straight-line distance between the centers of two mea-
suring points.
F10115A
(2) (Two-dimensional distance)
D
Horizontal distance in forward/rearward between the
centers of two measuring points.
D
The height from an imaginary standard line.
(b) In cases in which only one dimension is given, left and right
are symmetrical.
(c) The dimensions in the following drawing indicate actual dis-
tance. Therefore, please use the dimensions as a reference.
F10116A
(d) The line that connects the places listed below is the imagi-
nary standard line when measuring the height. (The dimen-
sions are printed in the text.)
SYMBOL
The place that was lowered A mm from the under surface of
1
the rocker panel centered on the front jack up point.
The place that was lowered B mm from the under surface of
2
the rocker panel centered between 1 and 3.
The place that was lowered C mm from the under surface of
3
the rocker panel centered on the rear jack up point.
F10026A
Name
Advertisement
Table of Contents
