Vertex Standard LTR VX-2200 Service Manual page 27

Hide thumbs Also See for LTR VX-2200:

Table of Contents

15. Sequential Tone Deviation

Note: The "TX VCO Tune Voltage", "Max Deviation" and

"Modulation Balance" must be done before this alignment

is started.

Set the transceiver to CH1 (band center, wide devia-

tion) via the "Channel" box on the "Alignment" win-

dow.

Click the left mouse button on the "Sequential Tone

Deviation" button.

Click the left mouse button on the "Start" button.

Move the Slide Bar, as needed as, until the deviation

meter reading is 3.0 kHz ± 0.1 kHz.

Press the "OK" button on the window, the value of the

alignment for Sequential Tone Deviation will be saved

in the radio.

16. Termination

This completes the alignment routine. Press the "Exit" box

to save all settings and close the "Alignment" window,

then turn the radio off.

Alignment

G-15

Table of Contents