Vertex Standard LTR VX-2200 Service Manual page 25

12. Sub Audio Deviation <CTCSS>
Note: The "TX VCO Tune Voltage", "Max Deviation" and
"Modulation Balance" must be done before this alignment
is started.
Set the transceiver to CH1 (band center, wide devia-
tion) via the "Channel" box on the "Alignment" win-
dow.
Click the left mouse button on the "CTCSS Deviation"
button.
Click the left mouse button on the "Start" button.
Move the Slide Bar, as needed as, until the deviation
meter reading is 0.7 kHz ± 0.1 kHz.
Press the "OK" button on the window, the value of the
alignment for CTCSS Deviation (Wide Deviation) will
be saved in the radio.
13. Sub Audio Deviation <DCS>
Note: The "TX VCO Tune Voltage", "Max Deviation" and
"Modulation Balance" must be done before this alignment
is started.
Set the transceiver to CH1 (band center, wide devia-
tion) via the "Channel" box on the "Alignment" win-
dow.
Click the left mouse button on the "DCS Deviation"
button.
Click the left mouse button on the "Start" button.
Move the Slide Bar, as needed as, until the deviation
meter reading is 0.6 kHz ± 0.1 kHz.
Press the "OK" button on the window, the value of the
alignment for DCS Deviation (Wide Deviation) will
be saved in the radio.
Alignment
G-13