9. TX Power
Note: The "TX VCO Tune Voltage" must be done before this alignment is started.
Set the transceiver to CH1 (band center, wide devia-
tion) via the "Channel" box on the "Alignment" win-
dow.
Click the left mouse button on the "Power High" but-
ton.
Click the left mouse button on the "Start" button.
Move the Slide Bar, as needed as, so that the power
meter reading is 50 W ± 1 W.
Press the "OK" button on the window, the value of the
alignment for Transmit Power Level (Power High) will
be saved in the radio.
Click the left mouse button on the "Power Low-High"
button.
Click the left mouse button on the "Start" button.
Move the Slide Bar, as needed as, so that the power
meter reading is 25 W ± 1 W.
Press the "OK" button on the window, the value of the
alignment for Transmit Power Level (Power Low-High)
will be saved in the radio.
Alignment
G-9