Table of Contents
Advertisement
Additional wiring options
Connecting your accessory to tubular track
Y
ou can also connect the remote control box to tubular track using an 8" 3-pin female pigtail
(available separately, 6-82038). Plug in the 3-pin male connector of the control tower into the
3-pin female slot on the back of the remote control box. Next plug in the 3-pin male connector from
the box into the 3-pin female pigtail. Then attach the red wire to the inside rail position of the uni-
versal lock-on (6-24213) and the black wire to the outside rail position. See figure 4.
Follow these instructions to illuminate your control tower and activate figure movement.
• Push the knob down in the "ON" position; the figures will move and the anemometer will
rotate.
• Slide the knob forward illuminate the tower.
• With the knob in the forward position, push down to move the figures and rotate the
anemometer. Notice that the tower will stay illuminated.
• Slide the knob back to the "OFF" position to turn off the lamp in the tower.
Note
The white wire is not used when connecting your control tower to tubular track.
Control Tower
Remote
Control Box
Tubular track
Figure 4. Connecting a remote control box to tubular track.
3-pin male
connector
Black wire
7
3-pin male
connector
3-pin female
connector
8" 3-pin female pigtail
(6-82038)
Red wire
Universal lock-on
Advertisement
Table of Contents
