Connecting Your #154 Railroad Crossing Flasher With The Fastrack Track System - Lionel 154 Owner's Manual

Connecting your #154 Railroad Crossing Flasher with the FasTrack
Track System
T o operate this accessory with the FasTrack track system, you will need the Accessory Activator
Pack (available separately, 6-12029). To make the proper connections, the ends of the wires
should be stripped back 1/8" to 1/4".
Caution!
Only an adult should perform this task. Use a pair of wire strippers to strip the
wires. Always use care when stripping wires.
Simply connect the two wires from the Insulated Track section directly to your accessory's
power terminals. Refer to Figure 4. The accessory receives power from the track and operates at
track voltage. You must be sure that the track is given enough power to operate the trains and
your accessory. The accessory will operate only when the track is powered up and the train is
between the breaks in the rail.
Isolated section
Break
Figure 4. Track power connections
Insulated section
Notch
Bottom of
the Railroad
Flasher
6
Isolated section
Break