Table of Contents
Advertisement
5100-A2-GB22-10
Procedure
1. Turn Off your PC. Place your RTU on a flat surface near the PC.
2. Insert the DSL cable 6-pin plug into the jack marked DSL on your RTU. Insert
the other end of the cable into the DSL network access point.
PWR
LAN
1
0
.
3. This step is optional. Make this RS-232 connection only to accommodate
running the 5170 Diagnostic Utility. See Chapter 3,
Diagnostics
Utility, for a description of this utility.
Insert the 25-pin connector on the shielded RS-232 cable into the connector
marked SERIAL PORT on your RTU. Insert the other end of the cable into
the serial port on your PC.
PWR
LAN
1
0
DSL
SER IAL POR T/V.3 5
DSL
Cable
DSL
SER IAL POR T/V.3 5
Shielded
RS-232
Cable
April 1997
Installation
496-15207
Using the HotWire
496-15208
2-3
Advertisement
Table of Contents
