Approvals - Siemens SIMATIC HMI KP Series Operating Instructions Manual

2.2

Approvals

Note
The following overview shows possible approvals for the HMI device.
The HMI device itself is certified as shown on the label on its rear panel.
CE mark
The HMI device meets the general and safety-related requirements of the following EU
directives and conforms to the harmonized European standards for programmable logic
controllers published in the official gazettes of the European Union:
● 2004/108/EC "Electromagnetic Compatibility" (EMC Directive)
● 2006/95/EC "Electrical Equipment Designed for Use within Certain Voltage Limits" (Low-
voltage Directive)
EC Declaration of Conformity
The EC Declarations of Conformity are kept available for the responsible authorities at the
following address:
Siemens AG
Industry Sector
I IA AS RD ST PLC
P.O. Box 1963
D-92209 Amberg, Germany
Explosion protection approval
For the HMI device
● EN 60079-0
● EN 60079-15
● EN 61241-0
● EN 61241-1
the following approvals are in place:
II 3 G
II 3 D
–
The design examination certificate is available at the following Internet address:
Technical Support (http://support.automation.siemens.com/WW/view/en/4000024)
KP8, KP8F
Operating Instructions, 10/2010, A5E03284305-01
II 3 G Ex nA II T4
Ex tD A22 IP6X T xx °C
x ... Temperature values, see design examination certificate
Safety instructions and approvals
2.2 Approvals
21