Table of Contents
Advertisement
Dimensions of the mounting cut-out
Multiple HMI devices are installed directly next to or under each other. The following image
shows the dimensions of the mounting cut-out and the required intervals.
Mounting Depth
The mounting depth for the HMI device depends on the type of construction of the
PROFINET connector. With angled PROFINET connector, order number 6GK1901-1BB20-
2AB0, the mounting depth is 65 mm.
The mounting depth does not match the external dimensions of the device. Plan for an
adequate bending radius for the cables connected to the HMI device.
KP8, KP8F
Operating Instructions, 10/2010, A5E03284305-01
Planning the use
3.5 Preparing for Mounting
35
Advertisement
Table of Contents
