Siemens SIMATIC HMI KP Series Operating Instructions Manual page 65

In the following image, the slot that must be set is labeled in red.
Procedure
1. Double click in the properties window on slot 2.
The "Properties – F-DI" dialog box opens.
2. Open the "Addresses" tab.
In the "Inputs" and "Outputs" groups, the start values of the address areas are set
depending on the controller used. The signals of the F channels of the HMI device are
mapped in these address ranges.
Parameter
Inputs > Start
Inputs > Process Image
Outputs > Start
Outputs > Process Image
3. Check the default entry of the addresses for "Start".
If necessary, change the address range.
4. Select the "Parameters" tab.
5. Open the "Parameters > Device-specific Panels > Evaluation of the Sensor" directory.
KP8, KP8F
Operating Instructions, 10/2010, A5E03284305-01
Meaning
Start of address range in which the safety-relevant usage data of
the HMI device are mapped.
Process image to which the address range belongs.
This parameter cannot be entered with a controller of the
SIMATIC CPU 300 type.
Start of address range in which the safety-relevant usage data of
the HMI device are mapped.
Process image to which the address range belongs.
This parameter cannot be entered with a controller of the
SIMATIC CPU 300 type.
Setting the KP8 and KP8F
6.5 Setting KP8F - STEP 7
65