Table of Contents
Advertisement
Manual for installation of the Sensformer® Connectivity Device
11. Overview to applied
standards and norms
Below listing gives an overview on standards and norms which
have been applied during the comprehensive testing phase in the
development process of Sensformer Connectivity Device.
List:
-
EN
61000-6-4:2007+A1:2011:
measurement
EN
61000-6-4:2007+A1:2011:
-
measurement on the mains and LAN lines
EN 61000-6-2:2005: Immunity test against radiated RF
-
disturbances
EN 61000-6-2:2005: Immunity test against conducted RF
-
disturbances on the AC, LAN and signal lines
-
EN 61000-6-2:2005: Immunity test against EFT on the AC,
LAN and signal lines
EN 61000-6-2:2005: Immunity test against SURGE voltages
-
on the AC lines
EN 61000-6-2:2005: Immunity test against voltage DIPs
-
-
EN 61000-6-2:2005: Immunity test against short voltage
interruptions
EN
61000-6-2:2005:
-
discharges (ESD)
MSZ EN 55032:2015: Radiated emission test
-
-
MSZ EN 55032:2015: Conducted emission test
MSZ EN 61000-4-2:2009: Electrostatic discharge test
-
MSZ EN 61000-4-3:2010: Radiated electromagnetic field
-
immunity test
MSZ EN 61000-4-4:2013: Electrical fast transient immunity
-
test
-
MSZ EN 61000-4-5:2014: Surge immunity test
MSZ EN 61000-4-6:2014: Testing the immunity to conducted
-
disturbances, induced by radio-frequency fields
MSZ EN 61000-4-8:2010: Power frequency magnetic field
-
immunity test
-
MSZ EN 61000-4-10:2017: Damped oscillatory magnetic field
immunity test
-
MSZ EN 61000-4-11:2018 and MSZ EN 61000-4-29:2002:
Voltage dips test
MSZ EN 61000-4-16:2007: Conducted common mode
-
disturbances
MSZ EN 61000-4-18:2007: 1 MHz and 100 kHz Damped
-
oscillatory wave immunity test
Radiated
RF
emission
Disturbance
voltage
Immunity
against
electrostatic
© 2020 Siemens Energy
Page 45
Advertisement
Table of Contents
