Table of Contents
Advertisement
Manual for installation of the Sensformer® Connectivity Device
REQUIREMENT
Must be providing circuit breaker, which can break the L (line)
and the N (neutral), but it cannot break the PE (protected
earth)! The circuit breaker device what it was chosen, it must
be certified! It must satisfy the IEC 60947-1 and IEC 60947-3
standards! The circuit breaker device must be 240 VAC with
1A. The circuit breaker device and the off-position and on-
position of the circuit breaker must be clearly marked during
installation! Inscriptions and/or markings shall ensure that
the pairing of the circuit breaker and the connected (secured)
equipment is clearly identifiable.
For more information, see the Installation requirements
chapter.
REQUIREMENT
The circuit breaker device must be close to the Sensformer
Connectivity Device! The recommended distance is lower
than 1 meter.
For more information, see the Installation requirements
chapter.
REQUIREMENT
Must be secured an overcurrent protection. It must be
certified! The overcurrent protection must be 240 VAC with
1A.
For more information, see the Installation requirements
chapter.
NOTE
If the environment requires, the overcurrent protection and
the circuit breaker device can be one device.
For more information, see the Installation requirements
chapter.
2. Insert the SIM card into the socket
CAUTION
For security reasons use SIM card with private IP address. Using
SIM card with public IP address makes the device visible on the
internet, exposing it to much higher security risk.
Mobile connectivity of the device can be ensured by using a
proper SIM card:
•
There must be a mobile internet subscription associated
with the SIM card.
•
SIM card must be activated by the mobile operator.
•
Use 2FF mini SIM card size.
•
SIM card must be inserted with the proper direction.
(as seen on the picture below)
•
PIN code must be disabled.
•
For security reasons use SIM card with private IP address.
•
The selected provider must not have APN username and
password.
•
APN setting of the device must set to the value got from the
mobile operator to the SIM card.
Figure 3 - SIM card size
3. Connect analog sensors
REQUIREMENT
Do not use the cables without ferrules. The ferrules must be
certified.
For
more
requirements chapter.
REQUIREMENT
The using cables on the analog inputs must be double insulated
and must
flame
rating.
For
more
requirements chapter.
© 2020 Siemens Energy
Figure 4 – Insert SIM card
information,
see
the
have UL 94 V-1 flammability classification and VW-1
information,
see
the
Installation
Installation
Page 8
Advertisement
Table of Contents
