1 General; Introduction; Symbols In This Manual; Preliminary System Check - Invacare Softform Active 2 Rx Service Manual

Invacare® Softform Active® 2 Rx
1 General
1.1 Introduction
This document contains important information about assembly,
adjustment and advanced maintenance of the product. To
ensure safety when handling the product, read this document
and the user manual carefully and follow the safety
instructions.
Find the user manual on Invacare's website or contact your
Invacare representative. See addresses at the end of this
document.
Invacare reserves the right to alter product specifications
without further notice.
Before reading this document, make sure you have the latest
version. You find the latest version as a PDF on the Invacare
website.
For pre-sale and user information, see the user manual.
For more information about the product, for example product
safety notices and product recalls, contact your Invacare
representative. See addresses at the end of this document.
1.2 Symbols in This Manual
Symbols and signal words are used in this document and apply
to hazards or unsafe practices which could result in personal
injury or property damage. See the information below for
definitions of the signal words.
WARNING!
Indicates a hazardous situation that could result in
serious injury or death if it is not avoided.
CAUTION!
Indicates a hazardous situation that could result in
minor or slight injury if it is not avoided.
NOTICE!
Indicates a hazardous situation that could result in
damage to property if it is not avoided.
Tips and Recommendations
Gives useful tips, recommendations, and information
for efficient, trouble-free use.
Triman
Indicates recycling and sorting rules (only relevant for
France).
3
1.3 Preliminary System Check
Before commencing any service procedure, the
following preliminary verifications should be
completed to ensure the system fault or failure is not
due to a user oversight.
1. Confirm the mains cable is firmly attached and the system
is connected to a working power source.
2. Make sure the handle is secured to the control unit. All
three connectors should be firmly inserted.
3. Remove the mattress top cover. Ensure the
cardiopulmonary resuscitation (CPR) label is firmly
attached.
4. Check that each air cell and side bolster is firmly attached
to the internal air tubes.
Once the preliminary system check is complete, proceed with
the service and repair as outlined in the following procedures.
60129676-D