Trip Computer - Audi A4 2013 Owner's Manual

Trip computer
Introduction
App lies to vehicles: with trip computer
The trip computer gives you information on
current and average fuel mileage, average
speed, fuel range and driving time .
Fig. 9 Trip comp uter disp lay: Average fuel mileage
The following info rmation is continuously
evaluated by the trip computer and can be dis-
played sequentia lly in the instrument cluster
disp lay:
Fuel range
The estimated cruising range in miles (km)
appears in the display. This tells you how far
your vehicle wi ll be able to travel on the cur-
rent tank of fuel and with the same driving
style. The disp lay changes in increments of 6
miles (10 km).
The cruising range is calculated based on the
fuel consumption for the last 18 miles
(30 km) . If you drive conservatively, the cruis-
ing range will increase.
Average fuel mileage
The average fuel economy in MPG (l/100 km)
since you last cleared the memory appears in
this display. You can use this disp lay to adjust
your driving technique to achieve a desired
mileage.
Current fuel mileage
The instantaneous fuel consumption in miles
per gallon (l/100 km) is shown in this disp lay.
You can use this display to adjust your driving
technique to achieve a desired mileage.
Driver information display 25
Fuel consumption is recalculated at intervals
of 33 yards (30 meters). This display switches
to gallons/hour (liters/hour) when the veh icle
is not moving .
Average speed
The average speed in mph (km/h) since you
last reset the memory appears in the display.
Elapsed time
The length of time that you have been driving
since you last reset the memory appears in
this disp lay.
Distance
The distance that has been covered since the
last time the memory was cleared appears in
the display.
(0
Tips
- Fuel consumptions (average and cur-
rent), range and speed are displayed in
metric un its on Canadian models.
- All stored values will be lost if the vehi-
cle battery is disconnected.
Memories
Applies to vehicles: wit h trip computer
The trip computer is equipped with two fully
automatic memories as well as an efficiency
program*.
Fig. 10 Trip comput er dis play: m emory leve l 1
You can switch between the trip computer 1
and 2 and the efficiency program* by pressing
the
I
RESET
I
button @ c::> page 26, fig. 11 .
You can tell wh ich memory level is currently
active by the number or the sign in the display .,..