Table of Contents
Advertisement
70
Seats
and storage
.::>
page 34 © .::> f ig. 76. This prevents any ac-
cess to the luggage compartment
from the
vehicle interior.
You can only enlarge th e luggage compart-
ment if the backrest is not locked.
~
WARNING
-
- The backrest must always be securely
latched so that the safety belt of the cen-
ter seating position can work properly to
help protect the occupant.
- The backrest must be securely latched in
position so that no items contained in
the luggage compartment
can slide for-
ward upon sudden braking .
- Always check whether the latch is fully
engaged by pulling the seatback for-
ward.
- Never allow safety belts to become dam-
aged by being caught in door or seat
hardware.
- Torn or frayed safety belts can tear and
damaged belt hardware can break in a
crash. Inspect the belts periodically.
Belts showing damage to webbing, bind-
ings, buckles , or retractors must be re-
placed.
(D
Note
- If
you move the front seat back when the
rear seat backrest is folded forward, you
could damage the head restraints on the
rear seat.
- Slide the belt guide on the outside safety
belt all the way up before folding the
backrest back forward. Make sure the
seat belt is not pinched or damaged
when the rear seat backrest if folded
back. Other objects should be removed
from the rear seat bench to protect the
seatback from damage.
Partition net (seatback in upright
position)
Applies to vehicles : with part it ion net
The partition net is designed to prevent loose
objects from flying forward into the passen-
ger compartment (e.g. under sudden brak-
ing).
Fig. 77
Behind the backrest : hang ing the part itio n net
Fig. 78
Behind the backrest: removing the partit ion
net
Hanging
.,. Pull the net upward . Hang the crossbar in
the rear eyelets
over the rear bench seat
¢
fig. 77 -arrow-.
Removing
.,. Tilt the seatback forward.
.,. Press the left and right release knobs
¢
fig. 78 -arrow- and pull the net upward
and out.
Installing
• Ti L t the seatback forward
¢
page 69 .
.,. Move the partition net left and right in the
retaining clamp .
.,. Press the partition net down diagonally at
the left and right until it locks into place and
the red markings on the buttons are no lon-
ger visible.
..,.
Advertisement
Table of Contents
