Audi A4 2013 Owner's Manual page 105

Table of Contents

Advertisement

Audi
a dapt ive crui se control
an d b r a kin g guard
10 3
A
WARNING
Imprope r use of the adaptive cruise con-
trol can cause collis ions, other accidents
and serious personal injuries.
- Pressing the
ISE TI
button whe n driving at
speeds below 20 mph (30 km/h), will au-
tomat ically accelerate the vehicle to
20 mph (30 km/h), which is the m ini-
mum speed that can be set.
@
Tips
- If you switch the ignition or the adapt ive
cruise control off, the set speed is erased
from the system memory.
- The elect ronic stabilization control (ESC)
and the anti-slip-regulation
(ASR) are au-
tomatically tu rned on when the adaptive
cruise control is turned on. Both systems
cannot be turned off if the adaptive
cruise control is turned on. Allroad: You
cannot switch the ESC to the offroad
mode when adaptive cruise control is
switched on.
Changing the speed
Applies to vehicles: with Audi adaptive cruise control
0
f
0
Fig. 116 Selector lever : changing the speed
.. To increase or reduce the speed in incre-
ments, t ap the lever up or down .
.. To increase or reduce the speed quickly,
hold the lever up or down unti l the red LED
®
reaches the desired speed
c> page
102,
fig.
115.
Following any changes, the new stored speed
will be displayed briefly in the display @
<=>page
102,
fig.
115.
Interrupting
cruise control
Applies to vehicles: wit h Audi adapt ive cruise contro l
Fig. 117 Selector lever
Requirement: adaptive cru ise control must be
switched on
c> fig.
117
(D.
Overriding cruise cont rol
.. To accelerate manually, press the accelera-
tor pedal. The message ACC override ap-
pears .
.. To resume adaptive cru ise contro l, remove
your foot from the gas pedal. The system re-
turns again to the speed that was saved be-
fore.
.,. You can save a new speed at any time by
pressing the
!SET I
button
c> page
11,
fig.
4.
Canceling cruise cont rol while driv ing
.. Move the lever into position @ . The mes-
sage ACC standby appears. Or
.,. press the brake pedal.
.. To resume the stored speed, move the lever
into position @ .
A
WARNING
-
Never resume the stored speed if the
speed is too high for prevailing road, tra f-
fic or weather condit ions .

Advertisement

Table of Contents
loading

This manual is also suitable for:

S4 2013

Table of Contents