Table of Contents
Advertisement
124
Homelink®
• To open the garage door, press the pro-
grammed button. The LED@ will light up or
flash.
• To close the garage door, press the button
again.
@
Tips
To open the garage door, press the button,
but do not press it for longer ten seconds
or the Homelink module will switch to
programming mode.
Programming the transmitter
(version
A)
Applies to vehicles : with Home li nk
Fig. 137 Distance between the radiato r grille and the
hand transmitter
You can program the fixed code and rolling
code systems using the described procedure.
Programming the button
• Turn the ignition on .
• There are two ways to program the button:
Press the button¢
page 123, fig. 136 that
you would like to program. Use the instruc-
tions that appear in the MMI* to perform
the programming. Or
• Select:
I
CARI
function button >
Car sys-
tems*
control button
>
Vehicle settings
>
Garage door opener> Program garage door
opener.
• Select the button that you would like to
program.
• Follow the instructions in the
MMI*.
• If the garage door opening must also be
synchronized with the Homelink module,
refer to the owner's manual for the garage
door opener.
Remote control units for garage door openers
in Canada are set to stop transmitting
radio
frequency signals after two seconds. This time
may not be sufficient for the Home link sys-
tem to learn the radio frequency signal. Per·
form all other steps as described above .
Erasing/Clearing the programmed button
settings
• To erase all of the programmed buttons at
the same time, select:
I
CAR I
function button
>
Car Systems"
control button
>
Vehicle set-
tings
>
Garage door opener> Clear pro-
gram settings > Yes.
The programmed but-
tons can not be erased individually . Repro-
gram the buttons if necessary.
• Reprogram an individual button in the same
manner that you would for the one-time
programming .
Displaying the version/status/country
code
• Select:
I
CAR !
function button >
Car sys·
terns*
control button >
Vehicle settings >
Garage door opener> Version information .
(D
Tips
- Programming using the MMI* is not
available for all vehicle versions.
- The required distance between the hand
transmitter
and the Homelink module in
the radiator grille ¢fig. 137 depends on
the system that you are programming .
- Depending on the model of the garage
door opener, you may need to release the
button on the remote and press it again
when programming. When program-
ming a new device, keep the button
pressed for at least 15 seconds before
trying again with the transmitter
in a dif-
ferent position.
Advertisement
Table of Contents
